What kind of production technology does fiberglass chopped strand mat?

1. Hand paste forming: Hand paste forming process is the main method of production of glass fiber reinforcement in my country. The glass fiber -cut felt, continuous felt, and sewing felt can be used for hand -shaped molding process. The use of sewing felt can reduce the number of layers and improve the efficiency of hand -confused operation. However, because the sewing felt contains more chemical fiber sewing lines, the bubbles are not easy to drive. The glass reinforcement products are more needle -like air bubbles, and the surface feels rough and not smooth. In addition, the messenger is stitched with heavy fabrics, and the molding properties are shorter and the felt and continuous felt. When making a complex product, it is easy to form an empty hole in the curved place. Hand paste forming process requires that the felt slices have the characteristics of fast resin dipping rate, easy to eliminate bubbles and good modeling.

2. Pull squeezing: Pulling the forming process is one of the main uses of continuous felt and sewing felt. Generally, it is mostly used with unwanted coarse gauze. Use continuous felt and sewing felt as a crowded product, which can significantly improve the ring and horizontal intensity of the product and prevent the product from cracking. Pulling the forming process requires that the fiber distribution is uniform, high tensile resistance, fast resin soaking rate, good softness and modeling, and felt chips should have a certain continuous length.

3.RTM: Resin transmission mold molding (RTM) is a method of closing mold molding. It is composed of two semi -molds and a pressure pump and injection gun in the yin model and yang model, without the need to press the press. The RTM process usually uses continuous felt and sewing felt instead of short -cut felt. It is required to have the characteristics of felt slices that are easy to be soaked by resin, good breathability, good resin tolerance, and good modeling.

4. Wind winding process: Generally, short -cut felt and continuous felt, which is used for richer lipid layers that are mainly used as products, including the inner lining layer and the outer surface layer. The requirements for the glass fiber felt are basically similar to that of the glass fiber felt.

5. Corporation of centrifugal casting: Usually short -cut felt as raw materials. Put the short -cut felt in the mold in advance, then add the resin to the rotating open -opening mold cavity, and discharge the bubbles through centrifugal to make the product dense. It is required to have the characteristics of easy permission and breathability.

#fiberglass #chopped #strand #mat